Summary of M08  (to UAM) 
  ============== 

  cycle  absorbers    absorbers     Comments
         delivered      good       
                    (Preliminar)  

  1       10G+4P      10G+4P     Fibertecnic reports: in most of the 
                                 plates the last digit of the lead number 
                                 can not be read.

  2       10G+4P      10G+4P     Fibertecnic reports: in most of the
                                 plates the last digit of the lead number
                                 can not be read.

                                 bun0136_05,bun0135_06_m08c02: two large
                                 hits producing deformation at acute edge,
                                 3-th wave. Try to repair at stacking site. 

  3       10G+4P      10G+4P     b0486_06 thicknesses too small. It was
                                 probably already at the lead (check it !) 

  4       10G+4P      10G+4P     b0898_04 surface distortion on SS at 
                                 acute-front edge. Prob. OK
 
                                 sun152_03 with at acute larger than at 
                                 obtuse. Probably mistyped.
                                  
  5       10G+4P      10G+4P
  6       10G+4P      10G+4P
  7       10G+4P      10G+4P     b0857_10: line of hits on top of folds 
                                 at the center (in eta) of the absorber      
  8       10G+4P      10G+4P     sun163_04: width at acute larger than 
                                 at obtuse + obtuse side not well enough 
                                 glued. Check it carefuly. 
  9       10G+4P      10G+4P     b0875_01: QCS reports an acute width
                                 1mm smaller than normal. Maybe is just 
                                 an error of transcription. 
                                 s341_01:QCS reports on one corner delaminated

 10       10G+4P      10G+4P   



       Total absorbers delivered: 100G+36P
       Total abs. good (prelim): 100G+36P